Page 93 - Industrial Ancillaries 2020 Catalogue (Sterling)

EMB DS Cutting Ring
Easy to Assemble
Cannot be Over-Tightened
2 Cutting Edges
EMB’s steel and stainless steel "DS" cutting ring is a rigid, optimised two-edge cutting ring featuring a secondary metallic seal.
Each cutting edge cuts in sequence, resulting in the capacity to withstand larger pull out loads and provide increased tube stability.
The second cutting edge reduces both transverse force and torque, and functions as a "physical stop" that prevents over tightening during assembly.
Evenly distributed force within the cone guarantees security.
A rising strength is imparted to the whole length of the ring and ows over the ring on to the body cone and the cone of the nut. This effect arises from the conical design of the inside end.
The conical surface opposite the cutting edges is highly nished, thereby reducing
the loss by friction during the installation and resulting in a stronger grip. Besides higher stability, the reinforced end of the DS ring reduces friction and takes the pressure off the base of the nut.
The required reduction of the cross-section optimises the radial stability & thereby keeps the tube secure. The stop area clearly limits overwinding by the bearing at the stud’s front surface.
DIN 2353 / ISO 8434
Stud Thread / Port DIN 3852
Tube Coupling
DIN 2353, ISO 8434
Nut
DIN 3870, ISO 8434
Gates DIN 2353 Coupling Range 02
Hydraulics
EMB Safety in Assembly
Port 24°
DIN 3861, ISO 8434
Cutting Ring
DIN 3861, ISO 8434
• EMB has a safe assembly solution for all applications
• Convenient, simple and short assembly times following straightforward
instructions
•100% controlled nal assembly of cutting rings
• Final turning in the stud only 30° (starting from pressure point)
•50% controlled pre-assembly of other manufacturers’ cutting rings
EMB Opticam, Type CAM 34
93